====== Settings the audio levels ======

You can adjust the audio levels with the potentiometers installed on the // SvxLink Card//. It is also possible by running this command from the Raspberry Pi:
<code bash>
alsamixer
</code>
{{ :fr:alsamixer.png?nolink |}}

To adjust the reception input level (microphone of the USB audio card), let's start to set the potentiometer to 3/4 of its stroke and set the software Mic adjustment // // (CAPTURE) to the high gain position (or maximum).

While generating a BF audio signal in the input of your reception, simply by speaking, you're going to decrease (adjust) the level of the Mic channel // // (CAPTURE) until a saturation of the input BF signal is not indicated. To be able to follow these 2 information's you'll need to open two term consoles: the first one dedicated to SvxLink and his tracking, the second one for the software level adjustment with alsamixer utility.

<code>
Rx1: The squelch is OPEN (4.44352)
Rx1: Distorsion detected! Please lower the input volume!
Rx1: Distorsion detected! Please lower the input volume!
Rx1: Distorsion detected! Please lower the input volume!
Rx1: Distorsion detected! Please lower the input volume!
Rx1: The squelch is CLOSED (3.55233)
Rx1: The squelch is OPEN (3.50789)
Rx1: The squelch is CLOSED (3.47806)
Tx1: Turning the transmitter OFF
</code>

<note important>Rembember to devalidate ''Auto Gain'', by selecting this cursor. Then, type the letter ''m'' on your keyboard for //mute// it. The letters ''OO' must be switch to ''MM'' </note>